Virtex4 : Downloading error

I created microblaze design using bases system builder for virtex 4 lx25 lc board using Xilinx EDK 7.1i sp2.

After downloading, when using xmd to connect, the following error happens..

JTAG chain configuration -------------------------------------------------- Device ID Code IR Length Part Name 1 0167c093 10 XC4VLX25 Assuming, Device No: 1 contains the MicroBlaze system WARNING:EDK - MDM Peripheral Not Detected on Hardware WARNING:EDK - Assuming opb_jtag_uart peripheral Connected to the JTAG MicroProcessor Debug Module (MDM) No of processors = 1

UNKNOWN Processor Version (0) Verify if FPGA Bitstream was downloaded and DONE pin went High

FPGA bitstream was properly built and downloaded to the system.

likely possible causes : 1. JTAG cable 2. EDK downloading issue like the ise

Any advice.

Thanks

Best Regards Shakith