Hi ,
When I tried to use Chipscope Pro Analyzer for programming the V2Pro fpga . I was able to succesfully connect the cables from PC to board.
But when I tried to do add a bit stream file created using jtagclk as start clk, I got the following error message.
ERROR: Wrong configuration stream for device INFO: Found 0 Core Units in the JTAG device Chain.
Please suggest me the solution for the same.
Regards, Kishore
schrieb im Newsbeitrag news: snipped-for-privacy@g14g2000cwa.googlegroups.com...
well it is exactly what the message says, you have bitstream for an device that doesnt match the device that you are trying to configure...
you can download with impact and then connect with analzyzer, do you see the core then?
antti
Have something to add? Share your thoughts — no account required.
Ask the community — no account required