Hi All,
I am going to buy a Usbmultilink programmer for program/debug MC9S08QG8.
The connector is USB interface, but my MCU already on PCB, I have to wire out the program lines.
Does it ok for me to do this ?
Best regards, Boki.
Hi All,
I am going to buy a Usbmultilink programmer for program/debug MC9S08QG8.
The connector is USB interface, but my MCU already on PCB, I have to wire out the program lines.
Does it ok for me to do this ?
Best regards, Boki.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required