was gfenau muss man macchen, um in Assembler den Int 0 des AT90
> scharfzumachen? es funktioniert hier nicht so.
Schau mal hier nach:
formatting link
Schau mal hier nach:
-- -> http://www.mikrocontroller.net
Steht alles im Datenblatt... aber bin ja nicht so:
ldi temp, 0b01000000 ; int0 aktivieren out gimsk, temp ldi temp, 0b00000010 ; int0 bei fallender flanke out mcucr, temp
Gruß Michael
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.