Where do I find this part?

Where do I find this part?....

formatting link

It's a rubber cabinet foot, made in the style of automotive panel fasteners... insert into hole, push pin in to lock.

My surfing comes up zilch.

Maybe some of you hardware designers would know of a source?

Thanks! ...Jim Thompson

--
| James E.Thompson, CTO                            |    mens     |
| Analog Innovations, Inc.                         |     et      |
 Click to see the full signature
Reply to
Jim Thompson
Loading thread data ...

What diameter hole does that fit, and how many do you need? A lot of computer cases used those, and I have some I saved.

--
You can't have a sense of humor, if you have no sense.
Reply to
Michael A. Terrell

Two sizes needed:

1/4" Qty Needed: 4 19/64" (as near as I can measure :-) Qty Needed: 4

Thanks! ...Jim Thompson

--
| James E.Thompson, CTO                            |    mens     |
| Analog Innovations, Inc.                         |     et      |
 Click to see the full signature
Reply to
Jim Thompson

you didn't say how many you wanted.

formatting link

google turned up this supplier too if you only want a very few.

formatting link

I typed "rubber feet" into google images.

also got some "wrong" aswers like

formatting link

--
?? 100% natural

--- Posted via news://freenews.netfront.net/ - Complaints to news@netfront.net
Reply to
Jasen Betts

"Jim Thompson" wrote in message news: snipped-for-privacy@4ax.com...

Keystone? Bottom of page.

Mouser - 094c each

Cheers

Reply to
Martin Riddle

Thanks, Martin! ...Jim Thompson

--
| James E.Thompson, CTO                            |    mens     |
| Analog Innovations, Inc.                         |     et      |
 Click to see the full signature
Reply to
Jim Thompson

is that 7.5mm metric?

Reply to
Robert Macy

I found three this size that look to be the same height as the one shown. I haven't been to my shop yet, but there should be about a dozen out there.

Still looking for these. I know there are a couple junk PCs with them, in the back of the TBS pile.

--
You can't have a sense of humor, if you have no sense.
Reply to
Michael A. Terrell

I take them off of expensive Agilent gear that is being placed into a rack.

You'd be surprised what HP and Agilent chassis parts and rackmount parts go for on E-bay.

I do not sell them there or otherwise. Jus' sayin'.

I have 3 c7000 slide mounts that are easily $150 each on ebay and far more from HP.

Reply to
SoothSayer

Thanks, Michael, Much Appreciated! ...Jim Thompson

--
| James E.Thompson, CTO                            |    mens     |
| Analog Innovations, Inc.                         |     et      |
 Click to see the full signature
Reply to
Jim Thompson

I found four of the larger size in a light gray. Is that OK?

--
You can't have a sense of humor, if you have no sense.
Reply to
Michael A. Terrell

Yes, Thanks! ...Jim Thompson

--
| James E.Thompson, CTO                            |    mens     |
| Analog Innovations, Inc.                         |     et      |
 Click to see the full signature
Reply to
Jim Thompson

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.