Long pin header needed

May 02, 2006 2 Replies

Rate this thread:

Dave Boland 20 years ago

I am doing some test cards that will be plugged into a mother card connector strop(.025" female, .100" spacing) and need to have the ability to easily connect logic analyzer pins on the top (see crude dwg. below). Looks like I need pin headers that are .270" (min.) on one side and .200" (min.) on the other side. Can't find anything like this -- any suggestions?

|| || Pin header on top of card, >= .200" +--||--||--+

+--+----------+---+ Card (.070") | |
+-----------------+ || || Pins (>= .200" exposed) || ||

Thanks, Dave

Vote

Pooh Bear 20 years ago

Try Samtec....

formatting link

They have lots of wacky stuff like that.

Graham

Vote

Tim Auton 20 years ago

RS here in the UK carry a range of pin headers with unusual dimensions, including one with 5.7mm above 7.6mm below, which is about right for your needs. They're made by 'Winslow Adaptics'. RS Export will ship globally, in case there's no supplier local to you (assuming you're not in the UK too!).

formatting link

Stock no. 251-8339

Tim

Did I really still have that sig?

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required