Hello to the group,
I am looking for a way to get pc boards that will allow me to mount a
40 pin micro, and still have some holes on either side of the pins to mount things like pulldown resistors, caps,etc.I have been using boards like the ones the ratshack sells. One rail on each side, middle is spaced for up to a 20 pin DIP and 4 or 5 holes on either side to mount other components to.
For reference, the ratshack board is called "experimenter printed circuit board" and the part number is 276-170. Datak makes boards similar to it (and a little less expensive), but when you mount a 40 pin DIP, there's not much room next to the pins to connect other components.
I have been to the expresspcb site, and they sound like a good way to go, but they only do double sided boards (I am not sure what that means). All I need is to mount components to one side and solder them on the other, with through holes, similar the the ratshack boards but either with more through holes on either side of the pins, or larger spacing to accomodate a 40 pin dip socket.
Any tips, tricks, links, or links appreciated.
TIA,
Joe