I've seen what I need: a 16 pin DIP header that plugs into an ordinary IC socket, but one with a ribbon cable coming off it.
But now that I need to buy one, I can't find the right terms to define same, at least to please DigiKey or Mouser. I keep getting wrong things.
But now that I need to buy one, I can't find the right terms to define same, at least to please DigiKey or Mouser. I keep getting the bare headers.
Suggestions?
-- A host is a host from coast to coast.................wb8foz@nrk.com & no one will talk to a host that's close.......................... Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433
I've seen what I need: a 16 pin DIP header that plugs into an ordinary IC socket, but one with a ribbon cable coming off it.
But now that I want to buy them, I can't find the right terms to define same, at least to please DigiKey or Mouser. I keep getting wrong things.
Suggestions?
-- A host is a host from coast to coast.................wb8foz@nrk.com & no one will talk to a host that's close.......................... Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433
Try IDC DIP header plug like
On DigiKey search on idc 16 pin dip header Then filter on in stock, 16 position,.300 row spacing to see the 4 possibilities.
David Lesher wrote on 9/22/2017 11:17 AM:
I searched Google for "16 pin dip ribbon cable" without the quotes of course. A couple of clicks and found this page.
-- Rick C Viewed the eclipse at Wintercrest Farms, on the centerline of totality since 1998
rickman wrote on 9/22/2017 12:41 PM:
Here's another brand.
-- Rick C Viewed the eclipse at Wintercrest Farms, on the centerline of totality since 1998
One key word is; Insulation Displacement connector.
The headers are usually sold separately and you press on the ribbon cable you want to use.
Pretty much the standard equipment for connectors to all hard drives preceding SATA.
That type of connector was easy to just nip up on the ribbon cable in a bench vise. An IDC ribbon cable header has pins that you need to protect - just pull all the pins out of an el-cheapo IC socket and use the shell to protect the pins.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.