Electronics Down Under

  1. Home
  2. Electronics Down Under
5133 Threads Posts
to

And Perth

Who can remember Handy Andies in Murray St. Crammed with old electrical and electronic stuff, weird smells, *real* war...
11 comments posted 19yrs
posted by bxvarley
11 comments posted 19yrs posted by bxvarley

2.4mm thick PCB

I'm looking for a supplier of blank, single sided 2.4mm thick PCB. Preferably in Oz, and preferably small sheets (say A4...
1 comments posted 19yrs
posted by me
1 comments posted 19yrs posted by me

What about Melbourne ?

** Hi all, RE all the Sydney based nostalgia: Who remembers " McGrath's " in Little Lonsdale Street ?? Tucked away in a...
30 comments posted 19yrs
posted by philallison
30 comments posted 19yrs posted by philallison

Changing face of Sydney's Silicon Alley.

In Sydney, the section of York street opposite QVB has been home to electronics stores for a very long time. In the las...
34 comments posted 19yrs
posted by woodag
34 comments posted 19yrs posted by woodag

powering a 555 off mains

I'd like to make a 555 PWM speed controller to drive a mosfet and switch a 240V DC motor that normally runs off a TRIAC...
8 comments posted 19yrs
posted by blargle
8 comments posted 19yrs posted by blargle

GPS and GSM modules -- where to get?

Hi, all I am after couple of embedded GPS modules, embedded GSM modules (modem and SMS ability required) and antennas f...
7 comments posted 19yrs
posted by aus_electronics
7 comments posted 19yrs posted by aus_electronics

RF Modules for sale

I have some RF modules for sale 433 MHz and 2.4 GHz ebay.com.au search for "RF module" Cheers Andrew
0 comments posted 19yrs
posted by vk4tec
0 comments posted 19yrs posted by vk4tec

McDonalds cheeseburger last longer

Story from New Zealand http://www.tv3.co.nz/VideoBrowseAll/CampbellLive/tabid/367/articleID/27647/Default.aspx?articleI...
1 comments posted 19yrs
posted by erty
1 comments posted 19yrs posted by erty

Flatbed Printer mod

I have built a flatbed printer from an old Epson Stylus 640 but need to fool the printer into thinking there is paper i...
5 comments posted 19yrs
posted by dave,pittam
5 comments posted 19yrs posted by dave,pittam

Cable connection help needed

G'Day, I am new here but am in need of help and this looked like just the place to get it - I hope ;
0 comments posted 19yrs
posted by tonyevans2
0 comments posted 19yrs posted by tonyevans2

Using a pager as a circuit breaker

I am trying to find information on how to configure a beeper (pager) to act as a power reset device for a remote radio...
1 comments posted 19yrs
posted by samllanas
1 comments posted 19yrs posted by samllanas

FPGA starter kit recommendations

Anyone here have any information they can offer about basic FPGA starter kits?. I'm not after anything spectacular to b...
12 comments posted 19yrs
posted by marcus
12 comments posted 19yrs posted by marcus