Model train inside a Christmas ornament

Nov 14, 2026 Last reply: 3 hours ago 3 Replies
Jump to replies (3)

Building a train small enough to live inside a bauble is the kind of challenge where every millimetre fights back, and that is where this project earns its praise. A clear two-piece plastic sphere sets a hard volume limit, and the finished locomotive measures only a few millimetres. A standard 0.4 mm nozzle could not resolve the model's ultra-thin walls, so the maker swapped the stock toolhead for a 0.2 mm hotend, seated with thermal grease, after slicing the model to check what the nozzle could resolve.



The locomotive was modeled in CAD software, printed on a Bambu Lab X1-Carbon on a textured PEI build plate, and then inspected under a digital microscope. That inspection paid off: the chimney, cab silhouette, boiler and wheel details all came through on the tiny black body.



The drive is a PCB linear motor, where overlapping planar copper coils in three phases push a permanent magnet along a defined path. The track is modular, with central header pads carrying 5V power and the three drive phases, plus curved footprints in 45 mm and 30 mm diameters. In KiCad, footprints for curved arcs, straight sections and link traces were tiled and rotated into a closed oval loop. With no schematic involved, free angle mode and allowed DRC violations were enabled, connection traces were routed by hand on the bottom copper layer, and the finished layout was checked in the 3D viewer.



Sketching the idea of unrolling a stepper motor's coils into a flat sequence makes the principle easy to follow, in my view. One open point stands out: heat in the linear motor approach. The design was adapted along the way while the wireless LEDs and the day/night effect were kept in.



Project by SeanHodgins. Watch it on their YouTube channel:

formatting link


Going as far as swapping the whole hotend instead of just tweaking print profiles seems like the right call to me. A 0.2 mm nozzle resolves the geometric details that a 0.4 mm one simply cannot, though the trade-off is slower printing and more careful handling on the textured PEI plate. Committing to the smaller orifice early, before the final print, is the part I would highlight.

One thing I am curious about: with the modules joined into one closed loop, how do the three drive phases and the 5V line stay connected across the joints? Are the link traces and the hand-routed bottom copper paths what carry the phases from one module's header pads to the next?

An improvement worth trying would be cutting the track into quarter-inch segments and powering two at a time instead of energising the whole loop. Far less copper would carry current at any given moment, which in my view should keep coil heating down and make that open question much less worrying for long running sessions.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required