I have this wireless USB adapter with a broken plug. Specifically, two of the contact points for the plug have become unsoldered. I have kludged my way past this problem in the past by using bits of tin foil to complete the circuit where the contacts where broken (don't laugh!), but for whatever reason, that doesn't seem to be working anymore. The power led for the device will light up just fine, but the link light will only light for a second, then go dim (in the best case scenario; sometimes it doesn't light up at all), and whenever I do a `lsusb` (Linux command to determine the bus ids plugged in usb devices) it isn't detected. Hotplug doesn't seem to find it either. If I move the plug around, I can get the leds to light up or dim though, depending on how I move it, although sometimes doing this causes kernel panics. I just thought that fact would be useful so that you all know how *I* know how the broken contact points are truly the problem. Needless to say, it's wireless networking capabilities remain, for the time being, null. Any ideas would be greatly appreciated. :)
- posted
17 years ago