Technics SL HD V600

Based on Panasonic history - either a bad spindle motor, which they've had many of the past several years, or a bad pickup. If possible try giving the disc a spin clockwise about the time it "should" spin. It might just take off and start running.

Mark Z.

I agree with Mark. " H02 " is officially spindle servo error, and it's very common for this to be caused by a faulty motor. Did one just last week, but it's not a very DIY-friendly job. I also agree that you can usually get it going by flicking the disc round at spinup time.

If it is motor, it comes ready fitted to a sub-deck, that you then have to swap the laser and some drive gears over to, and also a rotation sensor pcb under the turntable. When it is fitted, and working, you then have to align the three tilt adjust screws for minimum jitter factor, after you've invoked the built in jitter meter through a service test mode.

Arfa