I need to change the drive belt on the vcr it looks like I would have to pull the whole board out to get underneath the transport ,does this sound right or is there a better why of doing it,older vcr's you could take the transport out model number is Sylvania dvc-845 E any help? thanks
sylvania dual vcr/dvd combo
Jan 02, 2012
2 Replies
to
ny help?
In most the later centre-transport vcrs, you first have to remove the connectors to the heads then unscrew and remove the deck , then unclip and remove the pcb. It's not as bad as it sounds, tends to take under
10 mins.-B
In most the later centre-transport vcrs, you first have to remove the connectors to the heads then unscrew and remove the deck , then unclip and remove the pcb. It's not as bad as it sounds, tends to take under
10 mins.-B
Ok thank you finished it up today I had to take dvd rom out pull the one piece main board then 2 screws holding the transport to the board just to get to the belt ..older ones were easier lol I can't wait for spring fishing thanks again
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required