Recommend Electric Motor Protection: Fuses vs PTCs?

Now have a few fuse blown AC electric motors and am trying to decide if sho uld use a std fuse or a resettable fuse.

Have been trying to research this and recently found "Fuses vs PTCs..." Was interested in "Motor overcurrents can produce excessive heat that may d amage the winding insulation and for small motors may even cause a failure of the very small diameter wire windings. The PTC will generally not trip u nder normal start up currents. Motors are commonly protected by radial lead ed PTCs."

formatting link

Am interested in any comments concerning Electric Motor Protection.

Thanks

Ken

Reply to
KenO
Loading thread data ...

what size of motors are you dealing with here? Are they stopping and starting alot?

Did they work before and the blown fuse problem is new?

Recurring overcurrent protection device trips are an indication of something being wrong.

Reply to
Cydrome Leader

Hi Cydrome Leader,

Will try to answer all your questions.

"what size of motors are you dealing with here?" They are from Chinese 16" Oscillating Stand Fans similar to

formatting link

"Are they stopping and starting alot?" I inherited these fans as a "Learnin g Project" so do not know how they were used. From cleaning these fans do know that lint and dust built up over time so inadequate cooling due to blo cked airflow may have been the major cause for blown fuse.

"Did they work before and the blown fuse problem is new?" Correct, only ha ppened recently.

"Recurring overcurrent protection device trips are an indication of somethi ng being wrong." These fans only had std fuses so they were 1 time situatio ns that caused blown motors.

Am wondering if Resettable Fuses instead of 1 time fuses would work for the se fan motors so am interested in comments from anyone who has tried this.

Ken

Reply to
KenO

Ok, so it sounds like it's a small fan motor that now has, but didn't have problems. You've cleaned out dust from the motors. Have you lubricated the bearings?

The oil in fans like these gums up over time and the motors have to run much harder. This may be the reason they keep blowing fuses. My general rule is if the fan when switched off doesn't spin freely for at least several seconds, it's time for re-oiling. Same things applies if there's any hesistation in starting up. They should be upto speed in less than a second.

Reply to
Cydrome Leader

Are you using slow-blow fuses? Didn't say...

John ;-#)#

--
(Please post followups or tech inquiries to the newsgroup) 
John's  Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9 
 Click to see the full signature
Reply to
John Robertson

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.