Hi. i have a bench power supply made by PWR inc. wich has seem to stop existing. It seems that it was damaged by a line spike. I don't have any schematics but i do have a good knowledge of electronics. Anyone have working knowledge and/or any information of this unit or its manufacturer. It's a 40 vdc 200 amp variable power supply (SCR on the primary side) and the manufacturer is PWR inc. 15305 Stony Creek Way Noblesville IN
Thank-you
grodgers: First, with your "good working knowledge of electronics" you should open it up and perform some basic troubleshooting, component testing, and meter readings. If you are unable to diagnose the fault with that effort then you should post the exact symptoms with more words than "damaged"... and the results of your troubleshooting, component testing and meter readings. There are a lot of knowledgeable folks on this newsgroup that can give you repair suggestions but FIRST you have to post some better clues and more information.
-- Best Regards, Daniel Sofie Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
knowledge
200is
Have something to add? Share your thoughts — no account required.
Ask the community — no account required