When i plug for the first time it was dead tv and led blinking. So, i replaced vert ic TDA3653B (ic7400). Then i turn on and it was ok.After threee days TDA3653b blows again. Then i replaced again. Now it lasted just one day. What's going on? I checked diodes and caps around vert ic and they were ok. Any ideas? Thanks.
Philips TV 14GX8510--tda3653b keeps blowing and led blinking
Sep 02, 2005
2 Replies
Replace the diode and caps associated with the vertical circuit and make sure the TDA has clean heat compound on it.
Have you checked the esr in the electrolityc capacitors near the TDA or measured the capacity.
An electrolityc can have enough capacity, but an bad esr (internal resistance) can damage the circuit.
Greetings PP
schreef in bericht news: snipped-for-privacy@g47g2000cwa.googlegroups.com...
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required