TA8445k vert ic keeps blowing on this tv

Apr 27, 2006 1 Replies
A

It had just a horizontal line, so i changed the vert ic and a resistor



0.68 ohm (open) and its diode (shorted) near flyback. Then i turn on the tv and i had a normal picture for 2 seconds then horizontal line again. Now when i turn on the tv i hear just flub-flub-flub-flub and not even that horizontal line. Is that yoke busted? Any ideas? Thanks
Vote
Twitter Facebook LinkedIn
T

Make and model, FCC ID of the TV?

You had a vertical problem...you replaced some defective parts, but did not identify the actual cause of the problem, you missed at least one other defective part...you now have a second similar version of the problem, but not identical to it.

How are the parts that you replaced? Did you use the correct parts when you replaced them? Any solder bridges where you worked? What test equipment do you have?

Tom

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required