How to wire a stand alone ATMEGA328 chip

on an arduino UNO board (Blink sketch on pin 13). My problem is, I tried se veral times to wire the 238 ic on a breadboard but does not work. I have fo llowed all circuits connection on the Net to no avail (I tried the blink sk etch on pin 19 of the ic). in fact i used the 5 volts port and ground port on the UNO board to power the breadboard. I just saw a circuit on the Net w here pins 20 and 21 of the ATMEGA 328 ic were connected together. I want to Know if it is safe to do that to get the ic working will also be happy if someone can direct me to a site on the Net Thanks in advance should also add that a 10K ohm resistor was connected to Pin 1, two 22pf ca pacitors were also connected to pins 9 and 10 and other end grounded, 16M Hz crystal was also connected between pins 9 and 10. appropriate pins conne cted to power.

Have you never looked at the Arduino forum:

Paul