1. Home
  2. Electronics Repair
  3. Hitachi rear projo dead.

Hitachi rear projo dead.

Model # 50UX57B, Chassis # AP83R, dead. No startup in SMPS. After doing the following repairs, it just won't oscillate, no leds on the main PCB light at all. It was worked on elsewhere, both convergence IC's were replaced, & E995, E996, as well as IK04, & IK05. D910, & D911

12 volt zener diodes shorted, C707 near the flyback, & horizontal output are fine, the SMPS just won't oscillate! The three opto couplers check ok, as well as the SMPS electrolytics! Ideas anyone? Thanks, Dani.
Reply to
Dani
Loading thread data ...

Check the inverter transformer. It may have gone defective. You will need another one to try.

--

JANA _____

12 volt zener diodes shorted, C707 near the flyback, & horizontal output are fine, the SMPS just won't oscillate! The three opto couplers check ok, as well as the SMPS electrolytics! Ideas anyone? Thanks, Dani.
Reply to
JANA

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.