I can find any help about this in the manual. Is there a reset push button on the board, to recover a default code?
Bye,
Jean-Pierre Coulon
Forgotten lock code with a WEST P8100 temperature controller
Jan 10, 2023
Last reply: 3 years ago
5 Replies
formatting link
Will get you to the manual.
Page 35 of the manual will get you what you want.
The internet is your friend.
Peter Wieck Melrose Park, PA
... and search engines are your escorts.
It says "in the event that a lock code is forgotten press..." but the Cloc display they claim never shows up!
Jean-Pierre Coulon
Press ^ & @ together *WHILST THE UNIT IS POWERING UP* until the CLoc display is shown. Once in this mode Press @ to step between lock modes.
(I suspect that the manual means that you will be holding the ^ and the @ through the power-up process, not momentarily.)
^ = Raise Key @ = Function Key
If there is another fault, you may have to read more in the manual. Page 32 does also show the default and entry modes for the locks.
Peter Wieck Melrose Park, PA
Try 1234 or 9999 or 1111 or 0000?
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required