DIG_SD REV C 1x3 SDR board: verified supply and 30-pin connector pinout?

Nov 16, 2026 Last reply: 54 minutes ago 0 Replies

Looking for a primary hardware reference for the green PCB marked DIG_SD REV C 1x3, with Xilinx Zynq XC7Z020 and a separate AD9363 RF board. It appears in this published ZALA teardown:

formatting link
Clear published board photo:
formatting link



The external connector appears to be a 30-contact, two-row, 1.27 mm Samtec TFM/SFSD-family interface. A separate published ZALA wiring diagram labels a module only as VTU:

formatting link
That diagram gives a power connection, but it does not identify the PCB or revision, so it is not established that it applies to DIG_SD Rev C.



Does anyone have a manufacturer/integration document, a verified input-voltage and VIN/GND pin assignment for this exact revision, or a photograph showing this board with its original wired mating connector? Pin-1 orientation and an exact mating-connector part number would also help.



Please distinguish measurements or documentation for Rev C from guesses based on a regulator IC rating or a similar SDR. Earlier boards marked DIGITAL SD REV A also exist and should not be assumed identical.


Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required