Bad or good Lamp lnverter board for NEC LCD1830 wanted.

Jan 14, 2006 2 Replies
J

Repairing this LCD unit with bad inverter board, just fixed the main power supply with three capacitors, now working then find out inverter is also bad.



The part p/n on the board is: ALPS UHP061104, two transformers are same, transformer markings is 0053 1516S



Every inverter board I seen always had one bad HV transformer, shuts down in 1/2 of a second, see lamps lit up momentily every time power is applied.



All I need is either bad to obtain good HV transformer or good board.



Thanks & Cheers, Wizard


Vote
Twitter Facebook LinkedIn
J

Are you sure it is a bad transformer ? I never have had one with a bad transformer. It is usually the capacitor across the primary winding that becomes leaky and causes the inverter to shut down. I have had some with bad FET's that drive the transformer. I even substitued transistors in the TO-92 case for the SMD ones with good results. Have anice day... John

Vote
Twitter Facebook LinkedIn
J

John, I took the LCD and used scope to look at amptitude of sine wave, I'm very certain it is the transformer is bad, you can spot one by putting probe right on the transformer's side and see it on scope and compare to other transformer. The cap checks ok.

Search continues for lamp inverter that is bad or good.

Cheers, Wizard

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required