I have an Aiwa CX-NAJ14, that turns itself back on after turning it off. I t doesn't matter if it's turned off via remote or the front panel power but ton. The display says "good-bye" as most Aiwas do, displays the time, then about two seconds later it powers back up again. I haven't pulled the cov er off, but this seems odd. Maybe bad electrolytics? Has anyone ran acros s this problem before, or have a schematic for this unit?
Aiwa turns back on after turning off
Nov 23, 2012
3 Replies
It doesn't matter if it's turned off via remote or the front panel power b utton. The display says "good-bye" as most Aiwas do, displays the time, th en about two seconds later it powers back up again. I haven't pulled the c over off, but this seems odd. Maybe bad electrolytics? Has anyone ran acr oss this problem before, or have a schematic for this unit?
Ha ha, just fixed it. It's amazing how typing about a problem gets the min d working. I thought maybe it wouldn't turn off because the time wasn't se t, and wouldn't you know, that did it! Amazing...so simple! Way too often I ignore easy, obvious stuff.
You'd think the design engineers would have sorted that bug out pretty early in development though.
Gareth.
f.
er
time,
led
anyone
he
Wayrly
Well, it sorta makes sense, it is telling you to set the time, bet that's buried somewhere in fine print in a footnote in the instruction manual, maybe even in English.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required