Is there a market for a GenCad .CAD to .DXF convertor?
I've been asked to do a custom job to create a a GenCad .CAD to DXF convertor...in your opinions would there be a market for this in general?
Easy to use graphics effects:
formatting link
Market for a GenCad .CAD to .DXF convertor?
Mar 21, 2008
2 Replies
It would be good if you decided which groupS are appropriate BEFORE you posted-- then, instead of MULTI-POSTING,
formatting link
you would use *this* technique
formatting link
*-*-*-marked-as-Read-in-ALL-*-groups+Newsgroups.line
formatting link
*-*-*-*-*-*-*-*-appear+*-proper-answer-*-*-*-given+much-easier-*-*-*-*-*-*-*+*-frowned-on+*-correcting+*-Followup-To-*+*-*-_perfect_-*-*-*-*+*-*-*-too-lazy-*-*-*-*-*-appropriate-*+*-polite-*-mention-*-*-*-*-*-*-*+Just-because-*-*-*-*-*-*-*-*-does-not-mean-*-*-*-*-*-*+mark-*-*-*-*-all-*-groups+*-*-*-*-two-groups-*-*-aren't-*-different
formatting link
*-*-*-*-*-*-*-*-appear+*-proper-answer-*-*-*-given+much-easier-*-*-*-*-*-*-*+*-frowned-on+*-correcting+*-Followup-To-*+*-*-_perfect_-*-*-*-*+*-*-*-too-lazy-*-*-*-*-*-appropriate-*+*-polite-*-mention-*-*-*-*-*-*-*+Just-because-*-*-*-*-*-*-*-*-does-not-mean-*-*-*-*-*-*+mark-*-*-*-*-all-*-groups+*-*-*-*-two-groups-*-*-aren't-*-different
I've never even heard of GenCAD. It sounds
formatting link
like one of the dozens of niche mechanical CADs.
formatting link
Thank you for your reply.
Until I post I am unsure about who could answer the question. Unlike yourself, I did not leap fully formed from the womb with seerlike powers of gazing into the minds of the readers of these groups.
Easy to use graphics effects:
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required