Field-Programmable Gate Arrays

15255 Threads Posts
to

Active HIGH / Active LOW

Hi, There chips with the mixture of Active HIGH and Active LOW signals. Is there any pros and cons of each levels? OR it...
4 comments posted 21yrs
posted by muthusnv
4 comments posted 21yrs posted by muthusnv

FPGA configration Data/Firmware

Hi all I have no idea regarding low level hardware. I should firgure out something about ALTERA ACEX. Question is like...
0 comments posted 21yrs
posted by jdy0803
0 comments posted 21yrs posted by jdy0803

Asynchronous Inputs Question

Hi, I am implementing a state machine in a FPGA using VHDL. Several states are determined by 4 external event inputs (f...
6 comments posted 21yrs
posted by daveb_24_7
6 comments posted 21yrs posted by daveb_24_7

Init of BRAMs with ISE flow.

Hi All, I have several BRAMs in my design each needs its own set of constants. So far I have used the ucf file to store...
5 comments posted 21yrs
posted by nobbe
5 comments posted 21yrs posted by nobbe

IPIF

Hello! I am using an Virtex-II Pro Development Board. I have written my own OPB-Slave-IPIF and included it into a desig...
1 comments posted 21yrs
posted by norbert_abel
1 comments posted 21yrs posted by norbert_abel

Listing unrouted nets in FPGA Editor

Hello, how can I list unrouted nets in Xilinx' FPGAEditor via the command line? Is there a user's guide for the command...
1 comments posted 21yrs
posted by thomas.reinemann
1 comments posted 21yrs posted by thomas.reinemann

quartus hierarchy strangeness

Hi, I've been getting some strange behaviour compiling hierarchical vhdl files in quartus. The code is a vhdl reworking...
1 comments posted 21yrs
posted by nigel.gunton
1 comments posted 21yrs posted by nigel.gunton

Xilinx Virtex2p configuration

Hi, I experience problems with some "normal" IO's(not dual purpose IO's) on a Xilinx Virtex2p50ff1517. I observe that t...
1 comments posted 21yrs
posted by nospam.nospam
1 comments posted 21yrs posted by nospam.nospam

Lattice LFEC20

Anybody received LFEC20 samples from Lattice and using them? rick
0 comments posted 21yrs
posted by me
0 comments posted 21yrs posted by me

EDK 6.2 Synthese Error

Hello When I run the synthese with the XST, everything works fine until the optimization of one of my units. Optimizing...
0 comments posted 21yrs
posted by Patrick.Bateman23
0 comments posted 21yrs posted by Patrick.Bateman23

OPB IPIF user register interface

I have been trying for some time to get an IP I wrote hooked to the MicroBlaze. I am not immensely proficient with vhdl...
0 comments posted 21yrs
posted by tortoisedundee
0 comments posted 21yrs posted by tortoisedundee

changing directory location

I am getting the below error when i perform a post layout simulation from Xilinx using Modelsim. I am sure the $width p...
1 comments posted 21yrs
posted by vasus_ss
1 comments posted 21yrs posted by vasus_ss

Master Serial Programming

Hi , I have general question regarding the Master Serial Programming mode . In the Master Serial Programming mode , FPG...
3 comments posted 21yrs
posted by sowjanya_sn
3 comments posted 21yrs posted by sowjanya_sn