Xilinx Spartan 3 Configuration

Hi i have 3 X Spartan 3 to configure i followed the Master Serial configuration from the application note, but the sample only has 2 device to configure (i.e. Master FPGA and Slave FPGA); and the M0-M2 pins for the Master are connected to GND and to 2.5V with Slave. If i have 3 fpga to configure i have only one PROM, i will have a PROM, MASTER, SLAVE1, SLAVE2. etc. chain will the M0-M2 pins tied to 2.5 for all Slave FPGA? How about the JTAG for configuring the PROM? How about the Pull-Ups?


Reply to
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.