Hi, I want to implement a SCSI Ultra-160 or SCSI Ultra-320 host on a VirtexII-Pro FPGA. My goal is to connect the FPGA to an array of SCSI disks. This is proprietary link so I don't need full adherence to the specifications.
My questions are:
Thanks!
You can use the Virtex2pro for highspeed LVDS, but extreme care must be taken with the board layout when operating at those frequencies. Impedance control of your microstrip LVDS signal must be maintain from the I/O pins to the output connector. Most manufacturers will use external LVDS drivers an receivers because of this critcal routing. It is easier to place the external chips near the connector than the FPGA.
"Lucas" wrote in news:Y9cre.3$ snipped-for-privacy@twister2.libero.it:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required