PAR failed because "unable to find location..."
Sounds like I'm out of SLICEL .
Reports said SLICEL : 92%,SLICEM 2%, other kind of resources less than
Since there are a lot of SLICEMs left.Can PAR use SLICEM to replace SLICEL ? Are there some attributes I need to set?
Normally you would run out of SLICEM not SLICEL because SLICEM has everything in SLICEL plus a lot more. The error must be caused by something else. What does the error message exactly say?
Cheers, Jim
Have something to add? Share your thoughts — no account required.
Ask the community — no account required