Max Sample Rate using Signal Tap in Quartus 6.0?

Hello, I have a question concerning the maximum sample rate using Quartus' Signal Tap, I've heard that the maximum rate is 270Mhz, is that correct? Also, if you wanted to use a higher sample clock would you simply use a PLL to generate the clock and then route the clock to an output pin, which I think is a requirement of Signal Tap? If anyone has some experience using Signal Tap, could you share your thoughts on the matter.

Thanks, joe

Reply to
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.