Hello,
I need to program CoolRunner CPLD using an embedded controller. How to set the CPLD registers to work in the ISP mode?
Please explain how to do.
Regards, Chi
how to set the ISP mode for programming CPLD?
Jan 05, 2004
2 Replies
just put PORT_EN pin to '1' !
Laurent Gauch
formatting link
- In My design PORT_EN pin is connected to ground. Is it possible to enable ISP mode through instruction ISPEN command?
thanks and regards Chi
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required