ALL,
Good morning, I am building a calibration set-point device for the Hioki 3551.
To those who are familiar with batteries, the Hioki 3551 is a battery hiTester. That not only check your volatge. but also the internal resistance.
Does some one has an Idea, of how I would build a Battery simulator to use a calibration set-point device?
So far I came up with putting a load onto a 12vdc supply And I get a good voltage reading but not a good resistance read. It bounces around too much.
The way resistance is measured is via 1kz.. thru a wave detection circuit.
By the way I know there is a Hioki 3551 calibration manual out there. Does anyone have it?
If you live in the USA or it territories.. you can drop me a voice mail
1-800-699-2466
mailbox 5110121961
note to arjw:
I work for a living.. why can't you do that...???