Embedded Programming

16393 Threads Posts
to

How to improve SNR in Antenna Cirsuit Design

I am looking into an existing GPS mini-size patch antenna design (1575MHz), which includes an LC low-pass filter, an am...
8 comments posted 21yrs
posted by gpsabove
8 comments posted 21yrs posted by gpsabove

adc12138 problem

Hello there, I have been asked to write some software for an adc12138 that is residing on an ISA board for an industria...
1 comments posted 21yrs
posted by m.melton
1 comments posted 21yrs posted by m.melton

Design Advice

Hi All: I would like some design advice from those that have 'been there / done that'. We are designing a fairly simple...
5 comments posted 21yrs
posted by nospam
5 comments posted 21yrs posted by nospam

WTB: CAN starter kit

Hi, Can anyone recommend a good kit for getting started using CAN? If you have one you're not using and would like to s...
2 comments posted 21yrs
posted by nullset.spamtrap
2 comments posted 21yrs posted by nullset.spamtrap

Samsung DDR-behavioral model

I have a problem when simulating with samsung ddr behavioral model, I have tested my design with micron behavioral mode...
0 comments posted 21yrs
posted by ibrahim_magdy_ibrahim
0 comments posted 21yrs posted by ibrahim_magdy_ibrahim

Embedded Courses

Hi, I am looking for colleges with embedded courses in US. Can you just help me out. This is for my MS degree. I have s...
3 comments posted 21yrs
posted by brmadhukar
3 comments posted 21yrs posted by brmadhukar

Philips PDIUSBD12 Cannot Poll the interrupt Register

Hi, I am using the Philips PDIUSBD12. I am polling the device since I cannot use the interrupt pin. The part seems to w...
4 comments posted 21yrs
posted by martin_green
4 comments posted 21yrs posted by martin_green

ATMega48 I2C bus issues

Hi all! I'm building a small project, involving I2C communication. One side of the communicating partners is an ATMega4...
0 comments posted 21yrs
posted by andras_tantos
0 comments posted 21yrs posted by andras_tantos

Looking for a low cost solution

Hello All, I'm *very* new to embedded systems, please be patient. I'm looking for a low cost solution for two things: 1...
7 comments posted 21yrs
posted by miki.tebeka
7 comments posted 21yrs posted by miki.tebeka

binary divide by 3

I vaguely recall seeing a reference to an efficient algorithm for performing a divide by 3 on processors that only have...
4 comments posted 21yrs
posted by bxvarley
4 comments posted 21yrs posted by bxvarley

[Q] Old PC-ISA Data Bus Hold Time Requirement??

Hi all, I would like to know if the ISA-Bus specification requires a hold time for Mem/IO Read Cycle. I couldn't find t...
2 comments posted 21yrs
posted by meng.engineering
2 comments posted 21yrs posted by meng.engineering