Simulation of EDK based system with ModelsimXE


I am trying to write a custo-IP for microblaze(soft-core) based system. am using EDK7.1i, ISE7.1.03 and Modelsim-XE(verilog only). I am unable t simulate my IP with the hardware system using modelsim XE. Is there an work-around solution so that I could simulate my IP for the hardwar system using modelsim-XE. Basically my Ip sits on the plb bus. Can anyone give me some inf regarding BFM simulations.

Any help / suggestion is appreciated.

Thanks, Krishna. This message was sent using the comp.arch.embedded web interface o

formatting link

Reply to
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.