I'm being dragged kicking and screaming into this.
What irons, hot air equipment and solder are you using? Does your scrap rate increase?
OT - Anyone doing lead-free rework?
May 10, 2006
2 Replies
First reply
everything lead-free is a real PITA on any manual solder and re-work. there is no way to have it as simple and easy as it was before. Antti
Read the full replyeverything lead-free is a real PITA on any manual solder and re-work.
there is no way to have it as simple and easy as it was before.
Antti
Not really that constructive... Yes, it can be done. Just select the solder with most flux and for the TQFPs also use flux gel.
Rene
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
& commercial newsgroups - http://www.talkto.net
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required