Hi,
I'm working on the AT91RM9200-EK board. I've built my own u-boot for booting. My u-boot boots the board properly. It is completely fine. The problem is that when I follow the procedure to reprogram the flash, using the file on Atmel CD, loader.bin then using my u-boot.bin, I do not get a U-Boot prompt.
I am using the u-boot.bin on the Atmel CD for programming the flash and then use my u-boot.bin for final booting. I'm having problem in programming the flash on the custom board developed by me. I used a new flash chip which is different from the one on the evaluation board. So I've a requirement that I need to use my u-boot.bin to reprogram the flash.
Please give some inputs on this issue. I need my u-boot.bin to be able to reprogram the flash. (It should give me a prompt when I load my u-boot.bin using the XModem protocol.)
Thanks in advance...
Pj0585