Hello All; I have a Sansui 9090 since I bought it new. Other then a few small problems with it over the 30+ years I have own and operated it has been a great receiver. Reciently I was playing tunes, when suddenly the receiver quit playing. It was still powered up, and when I checked it out the switch warning was, and is flashing red constantly, when it should change to green after first turning on. It is an overload protection switch, and it won't change to it's normal green when all systems are go color. In the past if I were to drive it to hard, it would do the same, but after adjusting volume and bass down, it would be fine again.now it stays in this flashing red mode, and will not clear and turn solid green as it should. Has any one any ideas on this one. Thank You
Sansui 9090
Mar 10, 2007
4 Replies
Yes. The problem is that you don't know when to use "it's" and when to use "its".
Bob
I think you want to post this to scile.ectronics.repair.
Good luck,
John English
You most likely have bad caps and maybe an output transistor, why not post to the repair group.
"I\'m never wrong, once i thought i was, but was mistaken"
Real Programmers Do things like this.
http://webpages.charter.net/jamie_5
My idea would be to have it repaired.
Pierre Salinger Memorial Hook, Line & Sinker, June 2004
COOSN-266-06-25794
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required