Reflow oven for prototyping

Phil Hobbs · 2013-01-03T16:47:56+00:00

Hi, all, I need to be able to do some protos with DFN packaged devices with power pads on the bottom. If it weren't for the power pad, I could do it with my trusty Metcal, but things being as they are, I think I need a small reflow oven. Suggestions for how to get up to speed fast on medium-smallish (say 4x6 inch) boards would be very welcome. Thanks Phil Hobbs -- Dr Philip C D Hobbs Principal Consultant ElectroOptical Innovations LLC Optics, Electro-optics, Photonics, Analog Electronics 160 North State Road #203 Briarcliff Manor NY 10510 hobbs at electrooptical dot net

Jan 03, 2013 62 Replies

Rate this thread:

josephkk 13 years ago

wrong.

rising

inwards.

because

your

set

That so doesn't answer the questions.

?-/

Vote

John Larkin 13 years ago

Filling that one with solder would radically change the inductance.

John Larkin Highland Technology, Inc jlarkin at highlandtechnology dot com http://www.highlandtechnology.com Precision electronic instrumentation Picosecond-resolution Digital Delay and Pulse generators Custom laser drivers and controllers Photonics and fiberoptic TTL data links VME thermocouple, LVDT, synchro acquisition and simulation

Vote

Fred Bartoli 13 years ago

John Larkin a écrit :

I'd have thought it would have change its capacitance... Hmmm, rather the leakage resistance of its capacitance...

Thanks, Fred.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required