Hi guys, I need some help enlarging this picture of a circuit board to ID the resistor running horizontal, just to the left of the indexing hole of the big IC. (labeled R2)
Thank you, Mikek
The back story; My wife smelled something in the dryer room last Saturday, we traced it to the dryer. It was a burning electronic odor, I located the PCB and found two oozing capacitors, four bad diodes two bad 8.2 volt zeners plus the unknown resistor. I have replaced all but the resistor. If I get the value I'll replace the resistor and hope the 68HC705 microcontroller is still good. If replacing the resistor does not fix it, then it's about $70 for the PCB or an new dryer. Or maybe I can make it work and not have a dryness control setting, I don't use it anyway.