Hello Folks,
Ok, first, those card ejectors from RichCo and other mfgs don't seem to be in stock anywhere. Is there a place that sells them by the dozens and not truck loads?
Other: We've designed the boards per spec. Holes for the ejector 250mils in, boards exactly Eurocard length (160mm) but the boards aren't flush with the front rails of the VME cage. So maybe those ejectors wouldn't work anyhow.
Are there any "pull tools" available? We used to have those for ultrasound machines because ejectors were rattling to much. But that was many moons ago and I don't have the foggiest where they came from. Basically they caught the holes and then you cantilevered the board out. Of course, engineers didn't want to be sissies so we kept pulling by hand until thick callusses developed.