Potel DXP -> 99

orange, Not sure about the schematic version but the PCB is saved as Binary 4 or Binary 4.0. Can't recall the precise designated wording. There are approx. 3 Protel formats grouped together, whichever one is "4" something.

-- Sincerely, Brad Velander

they can be

You will actually loose quite a bit of info if you've used any of the new features in DXP. Even some of the polygon's may give you grief. I would actually advise against it unless you have a very good reason. Especially since there's the free viewer for the customer these days. I wouldn't do it myself unless I could load the design and DRC / check the resultant for correctness.

Simon