Hello I am using the PSPice Orcad
I have many drivers with the same voltage. Is there a way to do the simulation with only that voltage and use reference point to that voltage instead of using multiple line from the source to each driver. This would reduce a lot the amount of lines and would make things much clearer.
THANKS,
You can use net names. All wires with the same net name will be connected in the net list.
-- Mark
there are also teh power and ground symbols that name the net automatically, but lets you represent the power supplies they are attached to. Find under Place/Power and Place/Ground
-- Charlie Edmondson Edmondson Engineering Inc
Have something to add? Share your thoughts — no account required.
Ask the community — no account required