Where can i find a table of standard drill sizes used in the UK
Drill sizes
Apr 28, 2005
2 Replies
Hi Keith,
Don't know of any published table but drill sizes up to around 1.8mm are normally used/available in 0.05mm increments. Larger than 1.8mm in 0.1mm increments.
Above 5mm they are regularly routed.
In article , Keith Rathband writes
Roger M Unwin
P+M Services (R) Ltd Tel : 01706 815212 Fax : 01706 818636
http://www.p-m-services.co.uk
Keith, While I couldn't tell you about specifics in the UK, I would think that any size you can think of would be available within reasonable tolerances. Remember that you must allow tolerances. On most smaller holes (
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required