Electronics Repair

[OT] handrwriting conventions

I'm aware of a bar through a z , to distinguish z from 2 and a slash through 0 to distinguish zero from O. Anyone aware...

13 comments posted 9yrs

posted by diverse

13 comments posted 9yrs posted by diverse

I need bios -6-71-m74s0-d06a you have my bro....

I apreciat it ... tks, Cristian

0 comments posted 9yrs

posted by ctaestudo

0 comments posted 9yrs posted by ctaestudo

small wire

http://spectrum.ieee.org/nanoclast/semiconductors/materials/selfassembly-process-strikes-perfect-balance-for-making-nano...

0 comments posted 9yrs

posted by avagadro7

0 comments posted 9yrs posted by avagadro7

Best Phillips Screwdrivers?

For many years now, I have always used the black handle Xcelite Phillips screwdrivers with the chrome shaft & black tip...

50 comments posted 9yrs

posted by gwhite

50 comments posted 9yrs posted by gwhite

Can someone help us interpret what this patent says about a single torsion spring? (was: What does "urging" a clutch pedal mean versus what is a "treading" force?)

On Sun, 25 Dec 2016 18:44:58 +0000 (UTC), Frank Baron advised: > What does "urging" the clutch pedal mean? > (And what...

3 comments posted 9yrs

posted by frankbaron

3 comments posted 9yrs posted by frankbaron

HP LaserJet 4L toner sticks to OPC

I have an HP LaserJet 4L that has sit unused for five years, when last used it printed pefectly. Now I get this: http:/...

6 comments posted 9yrs

posted by JERONI.PAUL

6 comments posted 9yrs posted by JERONI.PAUL

I need bios Positivo 6 71 W54t0 D03

Does anyone have this Bios? I appreciate the answers. Good end of the year to all colleagues! Best Regards!!! Goiano

6 comments posted 9yrs

posted by ctaestudo

6 comments posted 9yrs posted by ctaestudo

How do I decide if these five tires are holed too close to the sidewall?

How do I decide if these five tires are holed too close to the sidewall? http://i.cubeupload.com/qD9rZv.jpg Yesterday,...

60 comments posted 9yrs

posted by frankbaron

60 comments posted 9yrs posted by frankbaron

Nikkai N64AU 12V inverter to mains

Dropped on hard floor and now just 1/2 second LED illumination. No sophisticated chippery inside, an LM324 and 2x TL494...

4 comments posted 9yrs

posted by diverse

4 comments posted 9yrs posted by diverse

Dell monitor - invokes factory reset at boot.

In the past week, my Dell monitor has developed the habit of doing a factory reset when the PC is booting up. I wouldn'...

10 comments posted 9yrs

posted by Benderthe.evilrobot

10 comments posted 9yrs posted by Benderthe.evilrobot

PbF and eyelets

Third time in as many months, usual PbF phantom problems, solder looks fine but no wetting between eyelet and pin and g...

13 comments posted 9yrs

posted by diverse

13 comments posted 9yrs posted by diverse

VGA to composite or S converter problems

I needed to convert the VGA output from my laptop to either S or composite video. I purchased this converter and althou...

7 comments posted 9yrs

posted by captainvideo462009

7 comments posted 9yrs posted by captainvideo462009

Revox A722

OK- I found one of these out of Luxembourg for (relative) sparrow-feed, lis ted as 'not working' that I snagged the oth...

23 comments posted 9yrs

posted by pfjw

23 comments posted 9yrs posted by pfjw

Best laptop battery care

We have several laptops that are rarely used. As best I can find, it is fatal to a Li Ion battery to go completely dead...

7 comments posted 9yrs

posted by NoEMail

7 comments posted 9yrs posted by NoEMail

Studiomaster powerhouse vision 12

Hi, I received this desk in bits, literally, in a huge bag and have slowly been rebuilding it. There were a number of d...

8 comments posted 9yrs

posted by Nightlight

8 comments posted 9yrs posted by Nightlight