Seeking transformer for Symphonic TV

Hi Mark...

I very much doubt that the transformer you're seeking is the problem.

Take care.

Ken

The transformer is not the problem. You need to troubleshoot the cause of the whine on the transformer.

First, I'd like to thank everyone who replied in such a short time and apologize for my delay in getting back to everyone.

I pulled the transformer out of the TV before I saw the replies trying to find a part number on this transformer after being told my a couple of Symphonic's local authorized support centers that the numbers on top weren't a part number. After several emails with Symphonic support, I finally found out that I did have the right numbers and that it's a $3 part. I haven't ordered it yet however.

I gave up at one point on getting this fixed and was looking into buying a Westinghouse 1080p Monitor. However, the w1 revision is at the end of it's run and BestBuy (pretty much the only retailer) isn't getting any new ones until the w2 revision comes out next month.

In the meantime, I thought about seeing what I can do with the TV I have before tossing it to the curb. I'm considering ordering a new transformer since I already have it sitting here on the desk next to me. In the meantime,I think I'll take a multi-meter to the primary supply side and see if I can find anything that's not reading as it should. Any guidance here would be appreciated.

Thanks again everyone....