i have a Robbins & Myers motor 3/4 hp 115/230 volts 3450 rpm 60 cycle wired for
230 and i need it wired for 115 volts how do i do that?
230 and i need it wired for 115 volts how do i do that?
Robbins & Myers motor 3/4 hp
Jun 15, 2016
2 Replies
230 and i need it wired for 115 volts how do i do that?
carefully.
ed
There should be a diagram inside the connector box or on the nameplate. If not, you will need to go to a motor-winder or similar service to ohm out th e windings and determine which are connected for 115V. It is not rocket sci ence, but unless you are quite familiar with motors, a mistake could be spe ctacular.
Peter Wieck Melrose Park, PA
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required