Hey group, have a RCA model #G27751AT. The screen is stretched horizontally. The horiz. adjustment has no effect. I tried tracing the circuit back from here, and tested a few components, but without a schematic, I'm kinda lost. Hoping somone with RCA knowledge here can get me pointed in the right direction. Thanks as always.
RCA width problem
Jul 20, 2006
5 Replies
"Golf" wrote in news:1153354194.860394.127110 @h48g2000cwc.googlegroups.com:
Is the horizontal stretched too wide or too narrow?
It is stretched too wide.
Look for a bad diode & or capacitor in the pin cushion correction circuit. Location CR4106 for the diode, & C4402, or C4403...not sure on the exact locations as they vary from set to set. Also, if you leave it much longer, it will kill the whole set. Hope this helps, Dani.
Golf wrote:
Thanks for the help, but if you could tell me the location of the pin cushion circuit...................I am fairly new to repair. I haven't seen any 4 number componenets. Only 3 number. Thanks again.
A drop in HIGH VOLTAGE ???, or has Horizontal Sweep frequency decreased ?? ie is the image normal except for the OVER Sweep or has the sweep frequency dropped low enough to show two images side by side ?
Yukio YANO
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required