Hi,
I've a VCR Philips VR630. The problem is that when I put in a tape and give a little push...... nothing happened!
Is this the case that the whole mechanism has to be re-initialised?
Can someone give a little hint before I buy a service-manual?
Thanks in advance!
Michel
On Fri, 11 May 2007 14:46:16 +0200, "M van Eijk" put finger to keyboard and composed:
If this model has an incandescent video lamp, then I'd suspect that. It should be in the middle of the deck, half way between the supply and takeup reels, and at about the level of the tension arms. It is designed to sit inside the hole in the bottom of your cassette.
While you're at it, I suggest you put a kit through it, ie video belts, idler tyre(s), pinch roller, tension band, mode switch.
- Franc Zabkar
-- Please remove one 'i' from my address when replying by email.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.