I recently hooked something up to the front AUX inputs and "POP", now i get "power off" on the display. I have looked at the test resistors in front of the amps, but they all seem normal. One shows a few volts but not the 60 volts talked about in other post.
Any ideas?
Thanks,
Fred
"A few volts" is still more than enough to trigger the protect circuit.
MarkZ .
Thanks Mark, I noticed on you other post that a skt4231 will work, I think I am going to give it a try.
Thanks,
Fred
If the output IC is a PAC007, yes, an STK 4231 II (Roman numeral2).
Mark Z.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required