I recently bought laser physics relant 300wc with a excalibur scanning engine mounted on the same board with it. I have to get it to a local shop to see if it works. My question is, "working or not, what is this thing worth?" Is it worth fixing? Im not looking to keep, but to get ride of it. Wwhen this thing was new, I guess this thing started out around $10,000 and went up to $14,000. Is this correct? Any info would be greatly appreciated!!!
Thx,
Rich Hopper rj snipped-for-privacy@yahoo.com
Didn't find your answer? Ask the community — no account required.
J
JeffM
This is not a buying-and-selling group. You are looking for a group with one of the following in its name: ads forsale marketplace biz
S
Samuel M. Goldwasser
Here are the specs: (From:
formatting link
Reliant 300WC
Output power 30mW to 300mW adjustable Wavelength 488nm-647nm Multiline Multimode, Polarized Current controlled power regulation
The range of wavelenths makes it a mixed gas (Ar/Kr) ion laser outputting blue, green, yellow, and red. That would be quite desirable if it is in working condition.
If it is working to spec, then perhaps $1-3K, a bit more or less.
If it is not working, not much though, especially if the tube is bad.
You should be able to power just the laser and measure the output power.
The optics in the scan engine will also be worth something.
-- sam | Sci.Electronics.Repair FAQ:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required
Report Content
You are reporting this content to the moderators. They will look at it
ASAP.