Model # AV-48WP30, it was picked by another shop, & the large stand up module (tin can type), that one of the plugs from the little convergence board goes to, has been out of the set, & put back with no screws, & MAY be bad, even though they don't commonly go. It had bad convergence. I replaced the stk 392-110 convergence IC's, & resistors. It convergences good, but the overall pix is shaped wrong, like bad pincushioning. Going from left to right the scan is up & down, both on top & bottom. I can adjust all service menu adjustments, but can't get it square. .Anyone see this problem? Dani.